Type | |
Stats | 3,242 15,693 |
Reviews | (363) |
Published | Mar 25, 2024 |
Base Model | |
Training | Steps: 200 |
Usage Tips | Clip Skip: 2 Strength: 1 |
Hash | AutoV2 85C6F01ED5 |
Just wanted to tweak a bit the view angle. The LECO ended up quite gentle and linear. I could train it further but i don't normally do big adjustment in the view angle, so I am fine with the granularity. If you wish to start higher or lower you can use From_Above and From_Below and do fine adjustments with the LECO.
For me it was stable from -5 to 5 I didn't have time to check further.
Until the XYZ plot was finished did i finally realize that i am dumb and you can't have a from_below angle for the on_back position because you would be inside the bed. :P
LECOs are manipulated by their weight and normally need no triggers to use it, change their weight like this <lora:AboveBelowView:-1> to lower the "camera" <lora:AboveBelowView:1> to Rise the camera. Remember you can go further than -1 or 1!